cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
282
Views
0
Helpful
1
Replies

PIX to VPN Concentrator problem

kevinhobson2000
Level 1
Level 1

Hi,

I am having a problem with a pix to VPN concentrator. Phase one gets to the MMKEY_EXCH stage and then drops. Output from the log of the concentrator below:

IKEDBG/65 RPT=52 <ip address> Group [<ipaddress>] IKE MM Initiator FSM error history (struct &0x3c51900) <state>, <event>: MM_DONE, EV_ERROR MM_WAIT_MSG6, EV_RESEND_MSG MM_WAIT_MSG6, NullEvent MM_SND_MSG5, EV_SND_MSG

cheers

Kev

1 Reply 1

Kamal Malhotra
Cisco Employee
Cisco Employee

Hi Kevin,

It seems that the preshared key is not matching. Please reconfigure it. Please also make sure that if any one end is behind a NAT/PAT device then we configure NAT-T. and that NAT/PAT device should allow the UDP 500 and UDP 4500 through it.

HTH,

Please rate if it helps.

Regards,

Kamal

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: