Solved: Frame-relay PVC

wgranada1 · ‎03-05-2007

Hi just had a quick question for you to disable a PVC all I have to do is disable the sub interface that is was created on? So if I have a pvc s0/1/0.22 and the PVC is 22 and I wanted to disable the PVC 22 all I would have to do is:

config t

inter s0/1/0.22

shut

???

Thanks in advance

IWAN HOOGENDOORN · ‎03-05-2007

Hi,

Just do a shut on the normal interface

inter s0/1/0

shut

That will disable the PVC of all interfaces regarding that interface/subinterfaces.

If you only want to disable the PVC of dome subinterface just shut the subinterface.

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

View solution in original post

IWAN HOOGENDOORN · ‎03-05-2007

Hi,

Just do a shut on the normal interface

inter s0/1/0

shut

That will disable the PVC of all interfaces regarding that interface/subinterfaces.

If you only want to disable the PVC of dome subinterface just shut the subinterface.

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################