CDP radio interface

Unanswered Question
Mar 5th, 2007

I use two 1310 aironet access point, the 1st link to my network by the ethernet interface is a root bridge and the other is a non root bridge. I'm using Cisco Works LMS to monitor my network. Right now i can see the root bridge in my map but i can't see the non root bridge. All the settings for CDP are enable on each interface on both access point. For best result i know that Cisco recommends to disable CDP on the radio interface but right now i am doing test and i will really appreciate to see the non root bridge in my map.

Is there anyone who have clues for me.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ebreniz Fri, 03/09/2007 - 13:41

Make sure the interfaces are working on the non-root bridges for which it is not working.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode