Multiple dsl connections in Single Router

Answered Question
Mar 5th, 2007

Hi,


I am trying to terminate two dls connections to the same provider in a single router. I have two HWIC interfaces in the Router. The router is a Cisco 1841 series.


When the dsl line is connected to Slot 0, router is connects without issue. When I connect to the HWIC is Slot 1, the dsl continues to terminate in on Dialer 1 which is bound to the HWIC in Slot 0.

The following is a snip of the config:


!

interface ATM0/0/0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

pvc 8/35

pppoe-client dial-pool-number 1

!

!

interface ATM0/1/0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

pvc 8/35

pppoe-client dial-pool-number 3

!

!

!

interface Dialer1

ip address negotiated

encapsulation ppp

ip tcp adjust-mss 1452

no ip mroute-cache

dialer pool 1

dialer remote-name isp-1-instance1

dialer-group 1

ppp authentication chap callin

ppp chap hostname isp-name-here-1

ppp chap password 7 1234567

!

interface Dialer2

ip address negotiated

encapsulation ppp

ip tcp adjust-mss 1452

no ip mroute-cache

dialer pool 3

dialer remote-name isp-1-instance2

dialer-group 3

ppp authentication chap callin

ppp chap hostname isp-name-here-2

ppp chap password 2345678

!


If anyone has any suggestions as it relates to the above, I would really welcome suggestions.


Thanks,

Ger.

Correct Answer by Danilo Dy about 9 years 11 months ago

I think the problem is in your "interface ATM0/1/0" which you have the line "pppoe-client dial-pool-number 3 " but you don't have the specific dialer interface which should be "interface Dialer3" when it can't find it, it uses "interface Dialer1". Try changing "pppoe-client dial-pool-number 3" to "pppoe-client dial-pool-number 2" in "interface ATM0/1/0"

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Danilo Dy Tue, 03/06/2007 - 04:51

I think the problem is in your "interface ATM0/1/0" which you have the line "pppoe-client dial-pool-number 3 " but you don't have the specific dialer interface which should be "interface Dialer3" when it can't find it, it uses "interface Dialer1". Try changing "pppoe-client dial-pool-number 3" to "pppoe-client dial-pool-number 2" in "interface ATM0/1/0"

Actions

This Discussion