03-05-2007 04:06 PM - last edited on 03-25-2019 03:53 PM by ciscomoderator
Hi,
I have a C2821 with a Switchcard - I wantto get the vlans working. I am used to C6000 Series, however this model does not allow for set commands etc I have tried to get VTP flowing between them - the card is known as GI1/0.
!
!
interface GigabitEthernet0/0
no ip address
shutdown
duplex auto
speed auto
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface GigabitEthernet1/0
no ip address
!
interface GigabitEthernet1/0.1
no ip address
!
interface GigabitEthernet1/0.1
encapsulation dot1Q 1 native
ip address 10.1.1.254 255.255.255.0
no snmp trap link-status
!
interface GigabitEthernet1/0.2
encapsulation dot1Q 2
ip address 10.2.1.254 255.255.255.0
no snmp trap link-status
!
ip classless
!
no ip http server
Show VTP Counters shows this:
VTP pruning statistics:
Trunk Join Transmitted Join Received Summary advts received from
non-pruning-capable device
---------------- ---------------- ---------------- ---------------------------
R-CORE-1#show vtp coun
VTP statistics:
Summary advertisements received : 0
Subset advertisements received : 0
Request advertisements received : 0
Summary advertisements transmitted : 0
Subset advertisements transmitted : 0
Request advertisements transmitted : 0
Number of config revision errors : 0
Number of config digest errors : 0
Number of V1 summary errors : 0
VTP pruning statistics:
Trunk Join Transmitted Join Received Summary advts received from
non-pruning-capable device
---------------- ---------------- ---------------- ---------------------------
R-CORE-1#
I have created a databse on the router but its not propergatting to the switchcard or a seperate switch ? What have I done wrong - I can't seem to use trunk commands on this but reading a cisco tech thing the above should work !?!?
I have added a switch plugging into the integrated switch and these are communicating fine:
VTP statistics:
Summary advertisements received : 3
Subset advertisements received : 1
Request advertisements received : 0
Summary advertisements transmitted : 3
Subset advertisements transmitted : 1
Request advertisements transmitted : 11
Number of config revision errors : 0
Number of config digest errors : 0
Number of V1 summary errors : 0
VTP pruning statistics:
Trunk Join Transmitted Join Received Summary advts received from
non-pruning-capable device
---------------- ---------------- ---------------- ---------------------------
Gi1/0/2 0 0 0
Fa1/0/16 0 0 0
Do you create the vlans on the integrated switch instead and ifso does this mean the router won be routing them ???
Thanks for any help
Ed
03-05-2007 09:45 PM
Hi,
You need to create VLANS with this command:
#vlan database
it will take you in another mode ..
If you find this post usefull
please don't forget to rate this
#########################################
#Iwan Hoogendoorn
#########################################
03-06-2007 02:53 AM
Hi,
I know that ;) I created a vlan database on the router but the problem is it isnt propergating to the integrated switch ??
Thanks
Ed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide