Timestamps not displayed with debugs

Answered Question
Mar 5th, 2007

Hi All,


At the moment I am still studying so please forgive this probably obvious issue!


I have the clock set which I have verified with the show clock command. This displays correctly with the correct time, date etc.


However when I issue debug commands I get the uptime? values, ie 3d06hr.


What is it that I am missing here for the debugs to display the actual set time?


If it matters the router is a 2500 running 12.2(7r)XM1 as the IOS.

Correct Answer by spremkumar about 9 years 11 months ago

hi


can you also try this command under your router config ?


service timestamps debug datetime msec localtime show-timezone


But make sure that you hve proper clock time set on your router to have proper time getting displayed ...


regds


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
spremkumar Mon, 03/05/2007 - 22:07

Hi


Can you post out the config which you have done it out there in your router over there ?


regds


Correct Answer
spremkumar Mon, 03/05/2007 - 22:14

hi


can you also try this command under your router config ?


service timestamps debug datetime msec localtime show-timezone


But make sure that you hve proper clock time set on your router to have proper time getting displayed ...


regds


Danilo Dy Mon, 03/05/2007 - 22:16

Try putting these two lines in your config


!

service timestamps debug datetime msec localtime show-timezone

service timestamps log datetime msec localtime show-timezone

!

Actions

This Discussion