sh ccm-manager

mymite060708 · ‎03-06-2007

When I use this command at the bottom under : Error configuration history: I see a few lines like

Configuration Error History:

voice-port 0/3/0:15

echo-cancel coverage 8

end

voice-port 0/3/0:15

echo-cancel coverage 8

end

controller E1 0/3/0

no pri-group timeslots 1-31 service mgcp

end

interface Serial0/3/0:15

no isdn bind-l3 ccm-manager

end

++++++++++++++++++++++++++++++++++

Can I clear these or find out why there was an error

Thanks

Erick Bergquist · ‎03-06-2007

You can enter the commands manually on the router and see why they did not take. Also, can do a debug ccm-manager config-download to see the config being applied when it is done. The router TFTPs the config from the CCM and then basically pastes the commands in to the router behind the scenes.

Do you have a Controller 0/3/0 interface, that may be the problem. I have seen this when the call manager has this module configured on the CCM side, but physically there is nothing in that slot on the router so the commands fail to take. If this were the case, you should also have a database configuration error in the event log on the call manager server at around time the ccm-manager cfg is attempted.