hi

Actully I have created access list as below

access list 101 permit ip any host 10.10.10.1

access list 101 permit ip any host 10.10.10.2

access list 101 permit ip any host 10.10.10.3

access list 101 permit ip any host 10.10.10.4

Will be right ?

and I have applied this priority list to serail interface of my remote router.

Can u tell me i hve to applied on both the router?

One which is in my head office and other in my remote office.

mY Main concern that my remote site users should get this server application faster.

hi

thnaks for the information.

But today it was same issue .no much improvement on performance.

Any other way of queuing method to resolve issue ?

Hi,

I think the best solution would be if applicable :

you should apply classification and marking of your mail traffic on both user port and server port with a priority of AF31 or CS3

then on both side of your wan link you should apply LLQ (CBWFQ+PQ) with a class for mail and for this class in your policy map use priority percent.

if you look on the cisco website you should find some sample config.

Luc

hope it helps

Hi,

First, are you sure your ACL on BOTH sides describe the traffic correctly? As the traffic direction is different you need to exchange source and destination on one of your routers. Do you get matches (show ip access-list)?

Second, there are better queueing methods (depending on your IOS version), like CBWFQ.

If you like, then try CBWFQ, which could look like this in your case:

Server side router

ip cef

class-map match-all Mail

match ip address 100

policy-map Mypolicy

class Mail

bandwidth percent 50 !adjust to your needs up to 75%

class class-default

fair-queue

random-detect

interface Serial0/0

description line to your branch office

bandwidth 128

ip address 10.0.0.1 255.255.255.252

no fair-queue

service-policy output Mypolicy

access-list 100 permit ip host 10.10.10.1 any

access-list 100 permit ip host 10.10.10.2 any

access-list 100 permit ip host 10.10.10.3 any

access-list 100 permit ip host 10.10.10.4 any

Branch office router:

ip cef

class-map match-all Mail

match ip address 101

policy-map Mypolicy

class Mail

bandwidth percent 50 !adjust to your needs up to 75%

class class-default

fair-queue

random-detect

interface Serial0/0

description line to head office

bandwidth 128

ip address 10.0.0.2 255.255.255.252

no fair-queue

service-policy output Mypolicy

access-list 101 permit ip any host 10.10.10.1

access-list 101 permit ip any host 10.10.10.2

access-list 101 permit ip any host 10.10.10.3

access-list 101 permit ip any host 10.10.10.4

You need to adjust interface namings, IP addresses and the like to your envitonment.

I would also advise you to read f.e. "Enterprise QoS Solution Reference Network Design Guide Version 3.3" and especially the section about brach office QoS.

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/ccmigration_09186a008049b062.pdf

Finally: QoS does NOT create bandwidth! So if your line is too small for the traffic you have, only a line upgrade can help. QoS just sorts out, which traffic gets the little bandwidth available. 128k maybe not enough, taking into account emails with tens of MB attachements.

Hope this helps! Please use the rating system.

Regards, Martin