How to replace an AP on the WCS map

robmaldowsusom · ‎03-06-2007

I have an out of service AP 1131. I have a replacement ready to install but I'm concerned w/ the map on the WCS. How can I go about replacing the existing AP w/ the new AP while using the existing name?

Robert Maldonado

Sr. Systems Administrator

erik.estrada · ‎03-06-2007

Robert,

After installing the new AP and get it sync'd up with the controller.Rename the new AP. Then simply delete the first one from the map and add the newly installed AP to the map.

Shouldn't be to bad at all.

robmaldowsusom · ‎03-06-2007

Erik,

While it wasn't as easy as I would have hoped deleting the existing one prior to adding the one one worked out fine.

Thanks for your suggestion.