03-06-2007 06:22 AM - edited 03-05-2019 02:44 PM
Greetings,
I am planning to deploy a cat 6500 in native mode. I will be using it for switching (closet switch). I'm not clear how to assign the IP address to the switch, do I assign it to the interface loopback0 or inteface vlan1. I will appreciate your assistance. By the way this will be a VTP client switch.
03-06-2007 06:26 AM
Try this;
set interface sc0 2 172.21.x.x/255.255.255.0 172.21.x.255
Where the 2, after sc0 = the Vlan you want the management interface to be on.
03-06-2007 06:58 AM
The commands above are for the catOS. I am actually converting to IOS. Thanks for trying. The command I was looking is interface vlan1, the switch ip address will be assigned to this port. Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: