carl_townshend Wed, 03/07/2007 - 03:20

can you show me how I could control access to some servers by using a map, how would i set that up, the servers are on the same subnet as my users, can this still be done, an example would really help?


cheers

carl_townshend Wed, 03/07/2007 - 08:35

This is very good, can i do this on my 2950 switch? can you give me a config example of where I want to block traffic in the same vlan to my servers, ie my servers are in the same subnet as my clients, and in the same subnet, I want to block certain pc's on my lan going to the servers. hope someone can help as this will save me buying more equipment.


cheers

Actions

This Discussion