Nat translation

Unanswered Question
Mar 7th, 2007
User Badges:

How do I set my pix 525 nat translation to hide internal IP addresses to the maximum extent possible. I need to configure the NAT firewall so that outbound traffic appears as if the traffic had originated at the firewall.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Kamal Malhotra Wed, 03/07/2007 - 06:12
User Badges:
  • Cisco Employee,

Hi,


You need omething like :


nat (inside) 1 0 0

global (outside) 1 interface


HTH,


Please rate if it helps,


Regards,


Kamal

lavong3600 Wed, 03/07/2007 - 06:27
User Badges:

What is HTH

Should the global outside point to the router?

acomiskey Wed, 03/07/2007 - 06:31
User Badges:
  • Green, 3000 points or more

Not sure what you're asking there, but the above commands mean that everyone one the inside will be translated to the outside address of the pix.

Kamal Malhotra Wed, 03/07/2007 - 06:51
User Badges:
  • Cisco Employee,

Hi,


HTH is Hope That Helps. :-)


If the interface names are the 'inside' and 'outside' then you just go ahead and paste the commands sent to you earlier. Global outside is not a route command so it does not point to any other device. This means the traffic that needs to get NATed/PATed will be NATed/PATed to the outside interface of the PIX.


Hope That Helps,


Please rate if it helps,


Regards,


Kamal

Actions

This Discussion