03-07-2007 06:04 AM - edited 03-11-2019 02:43 AM
How do I set my pix 525 nat translation to hide internal IP addresses to the maximum extent possible. I need to configure the NAT firewall so that outbound traffic appears as if the traffic had originated at the firewall.
03-07-2007 06:12 AM
Hi,
You need omething like :
nat (inside) 1 0 0
global (outside) 1 interface
HTH,
Please rate if it helps,
Regards,
Kamal
03-07-2007 06:27 AM
What is HTH
Should the global outside point to the router?
03-07-2007 06:31 AM
Not sure what you're asking there, but the above commands mean that everyone one the inside will be translated to the outside address of the pix.
03-07-2007 06:51 AM
Hi,
HTH is Hope That Helps. :-)
If the interface names are the 'inside' and 'outside' then you just go ahead and paste the commands sent to you earlier. Global outside is not a route command so it does not point to any other device. This means the traffic that needs to get NATed/PATed will be NATed/PATed to the outside interface of the PIX.
Hope That Helps,
Please rate if it helps,
Regards,
Kamal
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: