03-07-2007 06:04 AM - edited 03-11-2019 02:43 AM
How do I set my pix 525 nat translation to hide internal IP addresses to the maximum extent possible. I need to configure the NAT firewall so that outbound traffic appears as if the traffic had originated at the firewall.
03-07-2007 06:12 AM
Hi,
You need omething like :
nat (inside) 1 0 0
global (outside) 1 interface
HTH,
Please rate if it helps,
Regards,
Kamal
03-07-2007 06:27 AM
What is HTH
Should the global outside point to the router?
03-07-2007 06:31 AM
Not sure what you're asking there, but the above commands mean that everyone one the inside will be translated to the outside address of the pix.
03-07-2007 06:51 AM
Hi,
HTH is Hope That Helps. :-)
If the interface names are the 'inside' and 'outside' then you just go ahead and paste the commands sent to you earlier. Global outside is not a route command so it does not point to any other device. This means the traffic that needs to get NATed/PATed will be NATed/PATed to the outside interface of the PIX.
Hope That Helps,
Please rate if it helps,
Regards,
Kamal
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide