cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
379
Views
0
Helpful
1
Replies

Multicast and Catalyst 3750

bgowdey
Level 1
Level 1

We have a large site that has been subnetted into 7 physical segments. Each segment is connected to a port on the 3750 and a stack of 3 Nortel baystack 470-48T switches. (3 switches backplaned to form 1 96 port switch) via multi-mode fiber. We are trying to eliminate AppleTalk from the network, since it is a school and has almost 400 Macintosh systems, however we are no longer able to print across subnets due to the fact that Appletalk is not routeable on the 3750.

Is it possible to configure a multicast vlan that includes ports 1/0/1 thru 1/0/7 and will route mDNS or another multicast service on HP printers? We can not depend on IP printing because of some specific software products.

Any help would be appriciated!

Reference (mDNS, Rendevous, Bonjour, Zeroconfig networking)

1 Reply 1

bbaley
Level 3
Level 3

Make sure that 3750 you have contians the (EMI) or Enhanced image.But you would need this to support fallback bridging since this 3750 doesn't support appletalk routing.Refer URL

http://www.cisco.com/en/US/customer/products/hw/switches/ps5023/products_configuration_guide_chapter09186a00801cde91.html#10

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco