Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
319
Views
0
Helpful
1
Replies

1000baseT only allowing 100Mb

rebecca.richards
Level 1
Level 1

‎03-07-2007 05:53 PM - edited ‎03-03-2019 04:04 PM

Hi Guys,

I have an Cisco 3845 with an NMD-36ESW-2GIG card installed. The two Gigabit ports on the card are not allowing me to do 1000baseT, only 10/100.

When I'm in interface configuration mode, I can set the speed to auto/10/100, not auto/10/100/1000 like I'd expect.

I need these interfaces to do 1000baseT.

Any ideas?

Thanks,

- Rebecca

Labels:
0 Helpful
1 Reply 1

steve.busby
Level 5
Level 5

‎03-07-2007 06:34 PM

Check this link to ensure you meet all the requirements for this module.

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a00801aca3e.html

(i.e., you're running 12.3(11)T and Cisco routers only support up to 2 EtherSwitch Network Modules)

HTH

Steve

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card