Amit Singh Wed, 03/07/2007 - 20:51
User Badges:
  • Cisco Employee,

Hi,


You can use " show interface serial x/y" and check the input/ output packet rate. This will give you an idea of how much the bandwidth is used in RX and TX. The output is an average of 5 minutes interval. If you want to change the interval to take some more granular readings, chnage the interval like :


conf t

int serial x/y

load-interval 30--> seconds


HTH,

-amit singh

bvsivaprasad Thu, 03/08/2007 - 00:16
User Badges:

Hi ,

i want exact current bandwidth to measure at that second through serial interface,any command is there.

spremkumar Thu, 03/08/2007 - 22:31
User Badges:
  • Red, 2250 points or more

Hi Siva


I feel you can also try out some NMS solution which can provide you the utilisation part..


Lots of freewares available in net which you can download and configure it accordingly..


regds


Actions

This Discussion