03-07-2007 08:22 PM - edited 03-03-2019 04:04 PM
Hi,
is ther any command in cisco routers to find the bandwidth over serial interface with out any third pary tool
03-07-2007 08:51 PM
Hi,
You can use " show interface serial x/y" and check the input/ output packet rate. This will give you an idea of how much the bandwidth is used in RX and TX. The output is an average of 5 minutes interval. If you want to change the interval to take some more granular readings, chnage the interval like :
conf t
int serial x/y
load-interval 30--> seconds
HTH,
-amit singh
03-08-2007 12:16 AM
Hi ,
i want exact current bandwidth to measure at that second through serial interface,any command is there.
03-08-2007 10:31 PM
Hi Siva
I feel you can also try out some NMS solution which can provide you the utilisation part..
Lots of freewares available in net which you can download and configure it accordingly..
regds
03-09-2007 03:23 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide