why did the Failover commands on ASA5510 take no effect?

Unanswered Question
Mar 8th, 2007


I am configuring Failover on two ASA5510,but some Failover commands take no effect when I entered them into ASA.

For exmaple:

I entered the following commands in the mode of ASA5510A(config)#:


failover lan unit primary

failover link FailOver Ethernet2

ip address standby

failover interface ip FailOver standby

Then,two-three commands above did not appear whem I used show run,why?




I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
abinjola Thu, 03/08/2007 - 21:19

Wow..thats interesting...

Anyways...do you see the above commands in the followng output :-

1)sh tech

2)sh run fail

also i am interested to know does this mean that failover is in effect even though the command are not showing up ?

do ya see failover process being populated in the coommand sh proc mem ?

Also reboot the firewall once and then try the commands

Lets take it from there....


This Discussion