03-08-2007 06:27 AM - edited 03-05-2019 02:47 PM
Need to find a way to load IOS in a 2801 router. I have username and password, but I am unable to download the Xmodem software...
03-08-2007 06:30 AM
You mean the 2801 router currently has no IOS?
Use Xmodem, its available in TeraTermPro and Microsoft Windows HyperTerminal. You just need the rollover (or console) cable.
However, for 2801 router you can still download the IOS image using TFTP from the ROMMON. Check this link http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bf9e.shtml
03-08-2007 06:32 AM
I can only go in ROMMON mode, and it shows no dir files and won't take any commands to set up IP addresses to do the IOS load
03-08-2007 06:38 AM
Check my first reply again, I just add a link :)
03-08-2007 09:19 AM
http://www.cisco.com/warp/public/130/xmodem_generic.pdf
Actually had a bad Compact flash card. New card and tried this procedure. Thanks
03-29-2007 09:37 AM
If you are using Windows use Hyperterminal
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: