Antonio Brandao Mon, 03/12/2007 - 05:36
User Badges:

Thanks, its work now.


but i still have a problem :


The machine is plugged to switch trough two nic interfaces, when i disconnect one of two links, the the channel continue working, and when i back to plug the disconnected link , the machine stops to respond ping.


what can be occuring ?


Thanks , Antonio



Jon Marshall Mon, 03/12/2007 - 08:54
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi Antonio


Does the machine stop responding to ping for good or does it drop packets for a bit but then the ping continues ?


If the latter it looks like it could be a spanning-tree issue.


Jon

Antonio Brandao Mon, 03/12/2007 - 10:45
User Badges:

Jon,


The interface stops to respond ping -t command..and to come back work again, i have to remove and to create the port channel interface on switch.


follow attached , the switch configuration.


Att


Antonio



Jon Marshall Tue, 03/13/2007 - 01:02
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Antonio


What is the status of the remaining port when you reenable the other port ?


Jon

Antonio Brandao Tue, 03/13/2007 - 05:18
User Badges:

Jon,

It?s working now,

I think the problem was in vmware esx 3.


After i had make some alters in some flags in network features, the system is working.


If i remove one of two interfaces and and i re-plug that, the system continues ping.


Thanks Jon.


mlebus Fri, 04/06/2007 - 18:08
User Badges:

Antonio,


Curious to know what changes you made in ESX.


We've seen the same problem and not found a satisfactory solution.


Thanks,

Actions

This Discussion