Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
350
Views
0
Helpful
1
Replies

Multicast NAT gre tunnel

jnetalich
Level 1
Level 1

‎03-09-2007 05:26 PM - edited ‎03-05-2019 02:49 PM

Using Catalyst 6504 with MSFC. Host on vlan2 generates multicast. Tunnel source from vlan5 to get around non-multicast elements. Tunnel works - multicast packets are received by listeners on the other end of the tunnel.

Within the 6504 MSFC, I want to nat the multicast source address. Packets appear to be getting to the tunnel before nat processing.

I tried policy routing to make the multicast packets go thru Loopback1, but appears that policy routing ignores multicast packets.

How can I implement nat on this router?

Labels:
0 Helpful
1 Reply 1

drolemc
Level 6
Level 6

‎03-15-2007 03:05 PM

I think if you are passing IGMP packets through the tunnel, then they wont be NATted. There could be other such type of packets that cannot be NATted. Please try with some different type of packets.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card