E1 configuration problem

Unanswered Question
Mar 11th, 2007
User Badges:
  • Community Spotlight Award,

    Spanish Member's Choice: May 2016

Hello I am trying to configure a WAN link using a E1 MFT VWIC2 on a router 3725 when I try to configure the second E1 tyo establish a PPP Multilink I gethe following error message:

%Insufficient resources to create channel group

er-cumana1(config-controller)#

*Mar 9 19:40:56: No Free HDLC resources (0)


I tried to upgrade from 12.2 to 12.3 version cause I only have 32 Mb on flash and 128 on RAM. Not enough to get a 12.4 IP VOICE version.


What do you suggest to solve this issues??

Is there a version that I can use to get both e1 up?


Thanks a lot for your time

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Danilo Dy Sun, 03/11/2007 - 19:46
User Badges:
  • Blue, 1500 points or more

When independent clocking is configured, the controller will support only one channel group. If more than one channel group is configured, the following error message occurs "%Insufficient resources to create channel group"


Router(config-controller)# clock source {line [primary | hits] | internal} [independent]


or check this link for global command "network-clock-participate"

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_command_reference_chapter09186a00800b350b.html#wp1001437

Actions

This Discussion