03-12-2007 06:35 AM - edited 07-03-2021 01:46 PM
I am still investigating this issue, but here is something discovered using the WCS templates to push out a wlan config to WLC 4402 controllers.
I created a new wlan template with wpa security, etc and broadcast ssid turned off (unchecked), saved it and then applied it to my controllers.
I then opened up the web interface of one of the controllers to verify and saw the new wlan, but it had broadcast ssid enabled! I then went to each controller and discovered the same issue. I do not recall seeing any caveats for this but will check again.
Running WCS ver 4.0.96.0
wlc ver 4.0.207.0
03-19-2007 06:00 AM
I observed the same phenomena... however, with the massive number of changes I needed to address, I didn't follow up with a TAC case though...
03-20-2007 08:25 AM
I saw the same thing only we have WLC ver 4.0.206.0 with WCS 4.0.96.0. Again, I didn't report it either. My bad...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: