Cisco VPN Client/IPSec tunnel issue on Cisco 877

Unanswered Question
Mar 12th, 2007

We have a customer who has 3 sites. Two sites have a Cisco 877-SEC-K9 and the other site has a Draytek 2800. All three sites have full-meshed VPNs. The sites that have Cisco routers are configured to use a GRE VPN tunnel whereas when connecting to the Draytek router site, an IOS IPSEC tunnel has been configured. These VPNs are all working.

However, recently the client has requested to have remote access into one of the sites that have a Cisco 877. Therefore we decided to implement Cisco VPN client configuration onto the router. Once the configuration was uploaded, the GRE tunnels continued to be active whereas the IOS IPsec tunnels to the Draytek were showing as DOWN-NEGOTIATING. Once the Cisco VPN client configuration was removed, these VPNs became active again.

I have attached the configurations both before and after adding the Cisco VPN client commands.

I would be grateful for any feedback on what might be going wrong!!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
kaachary Tue, 03/13/2007 - 03:08

Put the client config back in , and remove the following command:

crypto map riscryptomap client configuration address initiate

*Please rate if helped.

-Kanishka

Actions

This Discussion