PDM error

Unanswered Question
Mar 13th, 2007

Hello, I have installed a FWSM 2.3(4) and when I change a policy for example and I intend to save the config, the PDM shows this error:

"PDM received an error when one or more of the commands below were sent to the FWSM."

Someone could help me please?

Thank you and sorry for my bad English.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
hoogen_82 Tue, 03/13/2007 - 12:28

Run the same commands you tried sending through the PDM on the CLI. See what error comes out. Usually should do something with the wrong config statement.


agustinmar Tue, 03/13/2007 - 15:35

Thank you hoogen_82. The problem is that this error is showed in many times, that is, every time that I save the config. Moreover, I think that this problem is generated other problem, since my modules are working with failover and I think that the config isn't copied to the standby module.

Could you help me please?

Thank you for all.



This Discussion