I'm not very familiar with proper switch configuration or management, so please forgive me for asking the obvious.
We are experiencing a lot of network slowdown. We have 2924-XL and 2950 switches. All our PCs are hard coded with Class C IP address (XXX.XXX.24 and XXX.XXX.25 IPs with subnet mask of 255.255.254.0). All the Switches are addressed in the XXX.XXX.24 range with same subnet mask. No VLAN has been configured.
Should we set all ports to Auto-Auto and all PC NIC cards to Auto?
What problems will occur if some are set to Full-100 on both ends?
We have set all switch port connections to Full-100 on both ends. Further, the port connection to our Router is set to Full-100 with the router configured the same.
We are seeing utilization spikes.