Address determined by ???

wessam.sadek · ‎03-13-2007

i have a problem in some vlan and i am asking what is the different between (Address determined by setup command VS Address determined by non-volatile memory)

as you see in the sh ip int br

all vlan method is nvran but only the 71 and 110 is manual so can any one hel say to me how can i change it and what is this address determined ?

Interface IP-Address OK? Method Status Protocol

Vlan1 unassigned YES NVRAM administratively down down

Vlan5 10.0.0.1 YES NVRAM up up

Vlan10 10.0.10.1 YES NVRAM up up

Vlan11 10.0.11.1 YES NVRAM up up

Vlan20 10.0.20.1 YES NVRAM up up

Vlan21 10.0.21.1 YES NVRAM up up

Vlan30 10.0.30.1 YES NVRAM up up

Vlan31 10.0.31.1 YES NVRAM up up

Vlan40 10.0.40.1 YES NVRAM up up

Vlan41 10.0.41.1 YES NVRAM up up

Vlan50 10.0.50.1 YES NVRAM up up

Vlan51 10.0.51.1 YES NVRAM up up

Vlan60 10.0.60.1 YES NVRAM up up

Vlan61 10.0.61.1 YES NVRAM up up

Vlan70 10.0.70.1 YES NVRAM up up

Vlan71 10.0.71.1 YES manual up up

Vlan80 10.0.80.1 YES NVRAM up up

Vlan81 10.0.81.1 YES NVRAM up up

Vlan90 10.0.90.1 YES NVRAM up up

Vlan91 10.0.91.1 YES NVRAM up up

Vlan100 10.0.100.1 YES NVRAM up up

Vlan110 10.0.110.1 YES manual up up

Vlan120 10.0.120.1 YES NVRAM up up

--More--

Richard Burts · ‎03-13-2007

wessam

When the output indicates NVRAM it is indicating that the interface address configuration was previously configured, saved to NVRAM, and was read from NVRAM at bootup. When it indicates manual it is indicating that you have manually configured this interface since the last time that the router booted.

If you really want to change it, save the config to NVRAM (startup-config) and reboot the router. I do not believe that it will change anything that impacts what you are doing or any problem that you may be experiencing.

HTH

Rick

HTH

Rick

wessam.sadek · ‎03-14-2007

dear rburts;

thanks for your reply but i had configure this vlan and reboot the switch 4500 many time and it dint get from nvram so can you please advise