Take Care Second line

Unanswered Question
Mar 14th, 2007
User Badges:
  • " /> Participante em Destaque,

    Prêmio"Escolha dos membros": novembro de 2014

it is only possible to take care of one second line when we remove telephone of the hook. This creates a problem to use headset without wire in the table of the secretary

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Thu, 03/15/2007 - 06:55
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Wilson,


I am just guessing here but I think you may be running into this setting;


Set the Always Use Prime Line parameter to True in Cisco CallManager. Because this parameter is clusterwide, any change affects all the phones. There is no interruption to the call handling and no need to restart any service or reboot the Cisco CallManager server.


In order to change this parameter, log in to the Cisco CallManager Administration page and perform these steps:


From the Service menu, choose Service Parameters.

Choose Publisher CallManager Server > Cisco CallManager service.

Under the Clusterwide Parameters (Device - Phone) section, scroll down to the Always Use Prime Line parameter, choose True for this parameter, and click Update.



Note: The default value for the Always Use Prime Line parameter is False. If the flag is set to True, when the phone goes off-hook or the speaker button is pressed, then the primary line is chosen and becomes the active line. If a call comes in on the second line of a user, going off-hook makes only the first line active. In this case, the user must select the second line in order to answer the call. If the flag is set to False, the phone automatically chooses a line as the active line based on the line status.


From this doc;


http://www.cisco.com/en/US/products/hw/phones/ps379/products_qanda_item09186a00800a6763.shtml#q39


Hope this helps!

Rob


Actions

This Discussion