Load Balance outbound w/ NATs (routers two ISPs)

Unanswered Question
Mar 15th, 2007

I want to make the balancing of outbound of two ISPs. I made the following configurations, but he did not function. somebody can help me?

int s0: ISP-1

int s1: ISP-2

eth0 10.10.10.1/24

mail server 10.10.0.2

proxy/ftp server 10.10.0.3

---------------------BEGIN--------------------------------

int eth0

ip address 10.10.0.10 255.255.255.0

ip nat inside

int s0

ip adress 200.100.200.2 255.255.255.252

ip nat outside

int s1

ip address 200.100.130.2 255.255.255.252

ip nat outside

ip route 0.0.0.0 0.0.0.0 200.100.200.1

ip route 0.0.0.0 0.0.0.0 200.100.130.1

ip nat inside source static 10.10.0.3 200.20.7.130 route-map ISP-1

ip nat inside source static 10.10.0.2 200.20.7.129 route-map ISP-1

ip nat inside source static 10.10.0.3 200.13.15.25 route-map ISP-2

ip nat inside source static 10.10.0.2 200.13.15.26 route-map ISP-2

access-list 101 permit ip 10.10.0.0 0.0.0.255 any

access-list 102 permit ip 10.10.0.0 0.0.0.255 any

route-map ISP-1

match ip address 101

set ip next-hop 200.100.200.1

route-map ISP-2

match ip address 102

set ip next-hop 200.100.130.1

---------------------END--------------------------------

thanks

Cleverson Ferla

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
royalblues Sun, 03/18/2007 - 01:42

Cleve,

Can you change the access-list statements to the following and check

access-list 101 permit ip 10.10.0.3 0.0.0.0 any

access-list 102 permit ip 10.10.0.3 0.0.0.0 any

HTH, rate if it does

Narayan

Actions

This Discussion