Connect a 2950 with Accelar 1050

Unanswered Question
Mar 15th, 2007

Hi to all. I'm try to connect a Catalyst 6509 with a accelar 1050. In the Catalyst the interface has "Trunk Encapsulation dot1q" because this is a trunk interface, but I don't know how configure it in the accelar. Somebady has done this configuration and can help me? Or can help me in another way.

Thanks a lot.

Francisco Velasco

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pstebner1 Thu, 03/15/2007 - 12:22

Francisco-

As far as I can remember, the 1050 doesn't support VLANs, so you wouldn't need trunking on the Accelar, and you could remove that statement from the Cisco uplink port. VLAN 1 info will still be available on the Accelar.

HTH,

Paul

pachomedellin Tue, 03/20/2007 - 09:44

OK Paul. I appreciate your help. That's correct your opinion, I going to do your suggest. Thanks again.

Actions

This Discussion