03-15-2007 07:54 AM - edited 03-05-2019 02:56 PM
Hi to all. I'm try to connect a Catalyst 6509 with a accelar 1050. In the Catalyst the interface has "Trunk Encapsulation dot1q" because this is a trunk interface, but I don't know how configure it in the accelar. Somebady has done this configuration and can help me? Or can help me in another way.
Thanks a lot.
Francisco Velasco
03-15-2007 12:22 PM
Francisco-
As far as I can remember, the 1050 doesn't support VLANs, so you wouldn't need trunking on the Accelar, and you could remove that statement from the Cisco uplink port. VLAN 1 info will still be available on the Accelar.
HTH,
Paul
03-20-2007 09:44 AM
OK Paul. I appreciate your help. That's correct your opinion, I going to do your suggest. Thanks again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: