03-15-2007 09:58 AM - edited 03-03-2019 04:10 PM
Hi,
I have a 2M ATM circuit on RJ45. Is there any special requirement for a 2811 with AIM-ATM module to use the ATM circuit? Any sample config?
03-15-2007 10:54 AM
Lets say you have AIM card in slot 1 and VWIC card installed in WIC2 slot
network-clock-participate wic 2
network-clock-participate aim 1
network-clock-select 1 E1 0/2/0
controller E1 0/2/0
mode atm aim 1
interface ATM0/IMA3
no ip address
no atm ilmi-keepalive
interface ATM0/IMA3.77 point-to-point
pvc 1/77
ubr 3840
oam-pvc manage 0
encapsulation aal5snap
interface ATM0/2/0
no ip address
no scrambling-payload
ima-group 3
no atm ilmi-keepalive
Hope this helps.
03-15-2007 08:50 PM
Hi,
Unfortunately I do not have any VWIC card installed. Can I used the FastEther since the 2M ATM that the ISP provide is on RJ45?
03-15-2007 08:58 PM
Unfortunately you cannot get away by terminating at FastE, I know ISP provides RJ45 but that must be getting terminated on VWIC on 2811. RJ45 do not understand ATM format hence you would need a vwic at a minimum in order to turn up the ckt.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: