03-15-2007 12:53 PM
Does anyone know if you can do port monitoring (I want to use a sniffer on a particular port) on an 11503? If so, anyone know the command? Thanks.
03-15-2007 01:02 PM
If you are 7.2 and higher code then your answer is below
Hope it helps
Syed Iftekhar Ahmed
03-15-2007 01:06 PM
Sure you can. Use the setspan command.
http://www.cisco.com/univercd/cc/td/doc/product/webscale/css/css_810/cmdrefgd/cmdglobl.htm#wp1299043
Cheers.
-Alejandro.
03-15-2007 01:51 PM
Can you monitor more than one port to one destination port? Like ports 1, 2 and 3 to port number 4?
03-15-2007 01:59 PM
A SPAN session is the association of a destination port with a source port on the same CSS module. The port that is monitored is called the source SPAN (SSPAN) port.
SPAN can monitor the ingress path, the egress path, or both. You can configure only one SSPAN port in a CSS chassis.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: