CatOS to Native IOS

cisco · ‎03-16-2007

I am going for change of CatOS to Native IOS on my 6509 switch .After conversion of my config , is there anymore activity which i should plan for ?

regards

Neo

ankbhasi · ‎03-16-2007

Hi Neo,

Once you are done with the conversion of code and config from CATOS to NATIVE IOS you are good to go.

If you have 2 sups in your chassis then you can plan for redundancy between your sups using rpr or rpr+ or sso if you have sup 720.

HTH

Ankur

*Pls rate helpfull post

sungeorg · ‎03-16-2007

Hi Neo,

The link below explains the step-by-step procedure on System Software Conversion from CatOS to Cisco IOS for Catalyst 6500/6000 Switches:-

Hope this helps!

Best Regards,

Sunny.