03-16-2007 03:40 AM - edited 03-03-2019 04:11 PM
Hello,
I have a new 2811 with an PRI ISDN card installed (NM-1CE1B=) and can not seem to enable and configure it. I have tried the usual commands:
card type e1...
controller e1...
...but neither are accepted. It wont even accept configuring ISDN switch-type global commands. It doesn't appear to accept any ISDN commands at all. I have tried 2 differenet IOS levels which both state they accept ISDN:
Cisco 2811
c2800nm-advipservicesk9-mz.124-3g.bin
c2800nm-adventerprisek9-mz.124-9.T.bin
Can anyone advise a level of IOS to use pleased?
rgds
Phil
03-16-2007 05:12 AM
I think this card is not supported on your router:
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b1150.shtml
http://www.cisco.com/en/US/products/ps5854/products_qanda_item0900aecd80169bd6.shtml
03-16-2007 05:55 AM
Thanks for this link - looks like it's not supported.
Phil
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: