×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Static NAT after inbound traffic through Lan-to-Lan tunnel on a 3030

Unanswered Question

I have a unique situation where I would like to NAT "inbound" Post tunnel traffic on 3030 concentrators, for internal routing purposes.


I've configured NAT similar to the various posted examples for "outbound", pre tunnel NAT, but NAT isn't working... Are there any examples or how to guides for type of this configuration?


Is it possible to Static NAT after the traffic comes out of the tunnel?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion