PIX501 VPN SETUP IS NOT Passing Traffic

Unanswered Question
Mar 16th, 2007

I've setup a pix501 for remote access vpn using the cisco client and found some documentation on the setup and have done this before with no problems. I pasted my modified config into the pix with no problems and connected to it fine. it just doesnt want to pass any traffic. I thought it was a nat 0 issue and i cant prove it either way! Any help is appreciated attached is my complete configuration.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion