03-16-2007 01:35 PM - edited 03-11-2019 02:47 AM
I've setup a pix501 for remote access vpn using the cisco client and found some documentation on the setup and have done this before with no problems. I pasted my modified config into the pix with no problems and connected to it fine. it just doesnt want to pass any traffic. I thought it was a nat 0 issue and i cant prove it either way! Any help is appreciated attached is my complete configuration.
Thanks,
03-16-2007 01:42 PM
try adding
isakmp nat-traversal
03-19-2007 06:16 AM
You were Right-On! Thanks,
I totally forgot that command.
Thanks,
Pat
03-19-2007 06:23 AM
Good to hear.
please rate if it helped
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: