Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
497
Views
0
Helpful
1
Replies

2801 multiple adsl pppoe trunk to switch

danletkeman
Level 1
Level 1

‎03-16-2007 02:21 PM - edited ‎03-05-2019 02:57 PM

Hello,

I have four ADSL lines and I want to setup my 2801 to do pbr according to source ip. I have 4 linux routers doing the pppoe to our isp but I would like to have the 2801 doing the pppoe and the pbr to eliminate the linux routers. Can I trunk from the 2801 to a 2960 switch configure 4 vlans plug in the adsl modems directly to the switch and have the 2801 doing the pppoe? Or do I have to have an hwic-4esw?

If this is possible how would I configure the pppoe connections?

I have the trunk working as well as the pbr config working.

Thanks,

Dan.

Labels:
0 Helpful
1 Reply 1

drolemc
Level 6
Level 6

‎03-22-2007 06:54 AM

The following document shows how to configure a Cisco 1700 using the Ethernet WAN Interface Card (WIC-1ENET) to act as a Point-to-Point Protocol over Ethernet (PPPoE) client with Network Address Translation (NAT).

http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093fbf.shtml

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card