03-16-2007 09:46 PM - edited 03-05-2019 02:57 PM
I have two E1's to two different locations
How can I load balance between two . I am using IS-IS as Routing protocol
Regards!!
Mahesh
03-22-2007 07:13 AM
Load balancing is a standard functionality of the Cisco IOS? router software, and is available across all router platforms. It is inherent to the forwarding process in the router and is automatically activated if the routing table has multiple paths to a destination. It is based on standard routing protocols, such as Routing Information Protocol (RIP), RIPv2, Enhanced Interior Gateway Routing Protocol (EIGRP), Open Shortest Path First (OSPF), and Interior Gateway Routing Protocol (IGRP), or derived from statically configured routes and packet forwarding mechanisms. It allows a router to use multiple paths to a destination when forwarding packets.
03-22-2007 07:50 AM
By default it will load balance per-destination. If you enable cef switching you can use the per-packet interface command on your two e1s and load balance the traffic 50/50.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: