03-17-2007 03:38 AM - edited 03-14-2019 08:31 PM
Hello,
This is a basic question.
We've a router with a VIC2-2BRI interface.
If I configure the ports like this:
------------------------------------
voice-port 2/0
translation-profile incoming filter1
output attenuation -5
compand-type a-law
timeouts interdigit 2
connection plar 200
bearer-cap Speech
!
voice-port 2/1
translation-profile incoming filter1
output attenuation -5
compand-type a-law
timeouts interdigit 2
connection plar 400
bearer-cap Speech
dial-peer voice 1 pots
destination-pattern 0T
direct-inward-dial
port 2/0
!
dial-peer voice 2 pots
destination-pattern 0T
direct-inward-dial
port 2/1
------------------------------------
everything works right; If I call the telephone number associated to the first BRI ISDN port the telephone associated to the 200 number rings and if I call the telephone number associated to the second BRI ISDN port, the telephone associated to the 400 number rings.
The problem is this: if I enable the "service" command on the "dial-peer voice 2 pots", the service doesn't "answer" at all.
------------------------------------
dial-peer voice 2 pots
service script1
destination-pattern 0T
direct-inward-dial
port 2/1
------------------------------------
And If I enable the service command on the first dial-peer "dial-peer voice 1 pots" it answer to all the lines!
Can you help me in order to make the service answer only to the first voice port?
Thanks.
Solved! Go to Solution.
03-17-2007 04:56 AM
Which IOS? Have you tried using "incoming-called number" into the dial-peers?
Hope this helps, if so please rate post!
03-17-2007 04:56 AM
Which IOS? Have you tried using "incoming-called number" into the dial-peers?
Hope this helps, if so please rate post!
03-17-2007 06:25 AM
Thanks a lot, it works!
Marco.
03-17-2007 06:54 AM
Thank you for the rating. See:
http://cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml#topic12
At some point in the above document, you will read:
Step 4 (voice-port) is not applicable to voice or dial platforms such as AS5300, AS5350, AS5400, AS5800 and AS5850
I think that because BRI is a digital port, it falls into the case above.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: