cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
327
Views
0
Helpful
2
Replies

voip issue

shivlu jain
Level 5
Level 5

we have a problem with 7940 ip phone

whenever we power on "invalid application protocol" error comming on universal loader

And not a single key functioning

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Connect to DHCP / TFTP server that has log.

Press # when powering, release, then press 1234567890*#.

Observe TFTP request and make sure the phone is getting all the requested files.

z.zdravkov
Level 1
Level 1

Hi I have seen that problem many times. It is kind of firmware problem I think.

There is solution for that problem. Read about boot up process from tftp and share the needed files for the phone.

I'm using the following:

1. OS79XX.TXT - whish contains only that in the brackets (P003-08-4-00)

2. XMLDefault.cnf.xml - you have to change the name of the firmware again inside

3. P003-08-4-00.sbn

4. P0S3-08-4-00.sb2

5. P0S3-08-4-00.loads

6. P003-08-4-00.bin

I think that is enough but you may need SEPDefault and SEPmac-address files.

Be careful with P00 and POS.

Good luck.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: