03-19-2007 05:19 AM - edited 03-03-2019 04:12 PM
Hi Experts!
where/whene we use On the PIX access-list & Nat 0 Command together.any scenario like this issue.
10xs
Regards
Solved! Go to Solution.
03-19-2007 05:42 AM
How about if you have an IPsec tunnel to someone and you don't want to NAT to anything but just want them to see your internal addresses?
03-19-2007 05:30 AM
Hi,
NAT 0 is what is NOT natted, usually is the traffic that goes into IPsSEC for secure communication with a remote site. or, if you inside does not use NAT, is all traffic.
You configure the access-list to define this traffic.
03-19-2007 05:37 AM
HI p.bevilacqua
Any Scenario regarding this matter?
10xs
03-19-2007 05:42 AM
How about if you have an IPsec tunnel to someone and you don't want to NAT to anything but just want them to see your internal addresses?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: