PQ on inbound

Unanswered Question
Mar 19th, 2007


I want to get some priority queueing rolling on my router. I already have some in place that works fine, but I want to throw packets with a port destination of 5060 (sip) to the top of the heap. Here is what I have so far:

interface Serial1/0

ip address x.x.x.x

serial restart-delay 0

priority-group 1

interface FastEthernet2/0

ip address

duplex auto

speed auto

access-list 105 permit tcp any any eq 5060

access-list 105 permit udp any any eq 5060

access-list 105 permit udp any any range 16384 16484

priority-list 1 protocol ip high list 105

It seems to me when I do some debugging that it is only matching outbound packets to the access-lists. This would be fine, but all of the sip traffic is leaving from a tunnel interface, which doesn't have the "priority-group" command available. Is there any way to have pq throw packets to high priority when they enter the router?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Mon, 03/19/2007 - 12:49

High priority when entering the router doesn't make sense. On input, you can do Qos classification, rate limit, and few other things, but no prioritizing.


This Discussion