CSM-S with Verisign (Test) Certificate

simonstoll · ‎03-20-2007

Hi

I'm a SSL Newby, and I'm stuck installing a Verisign SSL Certificate on the CSM-S SSL Offloading Card. I generated the RSA Key pair, the trustpoint, I enrolled the cert. via the terminal method, then I copy/pasted the cert. to verisgn and I got a signd certificate back from them. Now they tell me that i have to install a intermediate certificate, how is that done? Do i also have to install a Root Certificate (and how is that done?)? Any help is welcome

Simon

Gilles Dufour · ‎03-20-2007

Simon,

there is an example in the documentation @

http://www.cisco.com/en/US/products/hw/switches/ps708/module_installation_and_configuration_guides_chapter09186a0080178e4f.html#wp1092246

Example of Three-Tier Certificate Authority Enrollment

In SSL software release 1.2, the SSL Services Module supports up to eight levels of certificate authority (one root certificate authority and up to seven subordinate certificate authorities). The following example shows how to configure three levels of certificate authority:

....

Gilles.

simonstoll · ‎03-20-2007

Hi Gilles

You saved my day (no my week), thank you for your help, I got it working now! And I think, i even understand why :-)

Best regards

Simon

PS: Do you want a rating?

Gilles Dufour · ‎03-21-2007

always rate if you can.

We don't do this for rating but it's good to see that the help was appreciated.

Gilles.