Installing inmage on Cat 4510 IOS SupV.

Unanswered Question
Mar 20th, 2007

I am in the process of upgrading the image on a Cat 4510 IOS.

When I do a show bootvar it shows the following

BOOT variable = not available

CONFIG_FILE variable not available

Configuration register is 0x2101

ignore-config: disabled

auto-config: non-recurring

console baud: 9600

I have entered the following:

# boot system flash c45....bin;c45....bin

# conf reg 0x2102

but when I do a show bootvar, it still shows the same as above.

I am wary of rebooting this now as I do not know if it will pick up the new download?

In addition do I write

boot system flash device:c4500.bin

or

boot system flash c4500.bin

Please help.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Tue, 03/20/2007 - 10:54

The statement would be boot system flash bootflash: . You must do a write mem before the boot statement will show up in the "show bootvar" statement.

londint Tue, 03/20/2007 - 11:14

Thanks Glen

It also shows

BOOTLDR = not set

even though on the Show version, there is a boot image.

Should I also isuse a bootldr statement or leave it as blank?

Actions

This Discussion