NM-ESW-16 and QoS

Unanswered Question
Mar 20th, 2007

I am trying to configure Auto QoS for VoIP on this switch module and it doesn't seem to work. It errors out applying the service policy in the outbound direction on the switchports. I have it installed in a 2811. Can anyone supply a sample QoS configuration for this switch network module that would effectively support directly attached Cisco phones?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
aghaznavi Mon, 03/26/2007 - 06:41

Try this

conf t

mls qos

int fa0/0

switchport mode trunk

mls qos trust cos

mls qos device cisco-phone

no shut

mlitka Mon, 03/26/2007 - 06:44

What is the best practice when it comes to trusting CoS vs. DSCP?


This Discussion