cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
264
Views
0
Helpful
2
Replies

CSM config ?? real server at another subnet ?

rico_hao40
Level 1
Level 1

I have a 6k and csm module,

Below is the scenario and my goal,

client ->6k(client gateway)->vip (on csm module)->serverfarm (real servers at another subnet -> gateway2->real servers. Is it possible working like this? I tried but failed.

If I use bridge mode, and directly connect the real server to 6k (server vlan side), everything is working. But I do need running some servers which locate at another subnet and can not be trunked to 6k. need help.

I searched cisco but all the case looks like directly connect real servers to CSM . I tried set static route under server vlan, not work too.

Thanks

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

Hi

Yes this should be possible, we do it here where i work. You should be able to use the static route on the vlan to make it work but you say you have already tried that.

Could you send a copy of the relevant config ?

Jon

Thanks, Jon. Here is my CSM config (at 6k)

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

module ContentSwitchingModule 9

!

natpool SP-TEST 172.16.27.240 172.16.27.242 netmask 255.255.255.0

!

vlan 11 server

ip address 10.10.10.254 255.255.255.0

!

vlan 10 client

ip address 10.10.10.254 255.255.255.0

!

vlan 27 server

ip address 172.16.27.254 255.255.255.0

!

vlan 26 client

ip address 172.16.27.254 255.255.255.0

!

!

probe PING icmp

interval 2

failed 2

!

serverfarm IDVLDAP

nat server

nat client SP-TEST

real 172.16.27.69

inservice

real 172.16.27.70

inservice

probe PING

!

vserver VIP-IDVLDAP

virtual 10.10.10.24 any

serverfarm IDVLDAP

idle 14400

persistent rebalance

inservice

#vlan 10 ip on 6k is my client default gateway.

!

interface Vlan10

description Client subnet

ip address 10.10.10.1 255.255.255.0

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

#the real server connect to 4k and vlan 27 ip on 4k is server's default gateway, server access vlan on 4k is 27.

!

interface Vlan27

description server subnet

ip address 172.16.27.1 255.255.255.0

!!!!!!

6k and 4k running EIGRP.

the regular layer3 traffic flow from client to real server subnet is

client10.10.10.x->10.10.10.1->172.16.27.1->real server172.16.27.x

!!!!!!!!

currnetly I use nat client and trunk vlan 27 from 6k to 4k, it works. But it is not what I want, I do not want trunk vlan 27 between 6k and 4k, I want use routed to get there. Please advise! T

Thank you all.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: