Barebones Pix VPN setup

ixholla69 · ‎03-20-2007

My Pix box has a ton of stuff in it and it's hard to figure out where exactly the VPN Information is. My question is this:

What are the necessary lines for the VPN Configuration in order to allow for a Home user to connect to the Pix 506e and establish a VPN connection that will give them access?

I'm using a 506e running 6.3(4)

ggilbert · ‎03-20-2007

Hello,

Look at the config and see the section that starts with the command

vpngroup

It will give you the groupname and the password will be ******

You need to know the password.

Presuming you have this configured already..

If you are going to configure it from scratch, here is config example.

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a00801e71c0.shtml

Rate this post, if it helps.

Thanks

Gilbert